News

The Hyundai Accent's rear suspension uses a coil-spring-over-shock design that is commonly called a rear strut. The OEM part number prefix 55360 identifies the right-hand rear shock absorber/damper on many Accent models; the complete number must include the model-specific suffix, such as 55360-1R000 for many 2012-2017 Accent (RB) applications. The matching left-hand unit is usually 55330-1R000. Always confirm with your VIN because older Accent models may use different suffixes. Replacing the rear shock/strut: raise the rear and support the axle or trailing arm; remove the lower mounting bolt and the upper trunk-area nuts; compress the spring only if you are disassembling the spring seat and bump stop; never use the shock absorber to hold the car's weight. If replacing only the damper, install the upper mount, hand-start the lower bolt, lower the suspension to curb height, tighten the lower bolt to approximately 90-100 Nm (66-74 lb-ft), and tighten the upper nuts to 34-45 Nm (25-33 lb-ft). Torque values are typical shop/repair-manual values, not a substitute for the exact Hyundai service manual. Hyundai does not specify a calendar replacement interval for shock absorbers; inspect at about 30,000 miles or when you see fluid leakage, broken mounts, uneven tire wear, or excessive bounce. Always replace shock absorbers in axle pairs. For 2026 sourcing, verify suppliers are currently certified to IATF 16949 and that corrosion-resistance validation includes accelerated salt-spray testing such as ASTM B117; check for e-coat, powder coat, and a smooth rod surface before installation.