News

Your rear seat is where guests ride, and sagging pads are what they remember. The Black Golf Cart Rear Seat Cushion Set for EZGO TxT, ST, ST Sport and Valor models replaces both rear cushions in one order. High-density foam, vinyl covers, mounting holes already in place.

This guide covers fitment, the real dimensions and the install. Everything here assumes a standard rear flip seat frame in sound condition.

Why owners replace the rear cushions

Factory rear pads run thin. On rides longer than a few minutes, riders feel the seat frame through them, and a season of sun fades the covers.

The upgrade pairs high-density foam with a weather-resistant, UV-protected vinyl cover. The foam holds its shape under adult weight, and the cover wipes clean after a dusty trip.

What high-density foam means in practice

Density is how much foam material is packed into the same space. Higher density pushes back instead of collapsing, so the seat does not go flat after one season.

The trade-off is weight. These pads are heavier than thin factory ones, which you only notice while lifting them into place. Once bolted down, the weight is a non-issue.

Will it fit your cart?

The set is cut for four EZGO models:

• EZGO TxT
• EZGO ST
• EZGO ST Sport
• EZGO Valor

Mounting holes come pre-installed. Line them up with the flip seat frame and bolt down — no drilling, no trimming, no measuring twice.

The real dimensions

For reference, comparable aftermarket cushion sets of this type typically sell in the $95-$107 range. Other pads, covers and interior trim for these carts sit in the interior parts collection.

Cushion set or complete flip seat?

Order the cushion set when the flip seat frame is straight and only the pads are worn. You keep your frame and hardware, and the job takes half an hour.

A bent, rusted or missing frame is a different repair, and padding will not save it. In that case the one-piece rear flip seat for EZGO TxT golf carts (1994.5-up) with black cushions replaces frame and pads together as a single bolt-on unit.

How to install the set

1. Remove the old cushions from the rear seat frame.
2. Set the new seat cushion in place and line its holes up with the frame.
3. Fasten it with the provided hardware.
4. Fit the back cushion the same way.
5. Push on each corner to make sure nothing shifts.

That is the whole job. No drilling, no wiring, no special tools.

Want the same set covered from the ordering side — fitment checks, buyer questions and care notes? The companion guide in this series walks through the same cushion set step by step.

Two mistakes that shorten pad life

Most vinyl covers die from abuse, not age. These two are the usual suspects:

• Pressure washing the seat — high-pressure water pushes past the seams and soaks the foam.
• Leaving the cart uncovered in full sun for months — UV is what hardens and cracks the covers.

Keeping the vinyl alive

Wipe the covers with a damp cloth and a mild cleaner now and then. Skip harsh chemicals, because they dry vinyl out and start cracks early.

Park in the shade or cover the seat when the cart sits for weeks. Caught in the rain? Leave the seat open to the air and the quick-dry material handles the rest.

RxV owners: this is not your part

This set fits TxT, ST, ST Sport and Valor bodies only. An EZGO RxV uses different seat pans, so these pads will not line up.

RxV owners need the black front cushion seat cover for the EZGO RxV instead. Matching the part to the cart model before you pay saves the return shipment.

Frequently asked questions