![[1]](http://koeep.com/cdn/shop/files/1_44c16fb0-dafe-4c82-a7ae-a1396b0d2c42_1370x.webp?v=1783199865)
![[2]](http://koeep.com/cdn/shop/files/2_73e19db9-805b-4499-8dad-2c44fb407039_1370x.webp?v=1783199870)
![18590-17G01 COMP BOOST SENSOR For Suzuki Vstorm 650 DL650 SV650 SV650A SV650S SA 6B93BC-57 [1]](http://koeep.com/cdn/shop/files/18590_17G01_COMP_BOOST_SENSOR_For_Suzuki_Vstorm_650_DL650_SV650_SV650A_SV650S_SA_6B93BC_57__1_1570x.webp?v=1783199418)
![18590-17G01 COMP BOOST SENSOR For Suzuki Vstorm 650 DL650 SV650 SV650A SV650S SA 6B93BC-57 [2]](http://koeep.com/cdn/shop/files/18590_17G01_COMP_BOOST_SENSOR_For_Suzuki_Vstorm_650_DL650_SV650_SV650A_SV650S_SA_6B93BC_57__2_1570x.webp?v=1783199423)
Complete Guide to Black Golf Cart Rear Seat Cushion Set for EZGO TxT, ST, ST Sport & Valor Models
Torn seams, flat foam, and grey vinyl mean the trim is finished, not the frame. New cushions over sound hardware is the cheap fix. A rear seat cushion set for the 1994.5-up TxT, ST, ST Sport, and Valor models costs $108.74.
Check one thing before you buy. Cushions are trim, and trim needs a frame to sit on. If your cart has no rear seat frame, you need a full seat kit instead.
Which carts this set actually fits
Soft trim follows the seat pan, not the model badge. The pan is the flat plate under the cushion that spreads your weight. So fit is a chassis question.
This set is cut for the rear pan of the 1994.5-up E-Z-GO frame family. That covers three groups:
- EZGO TxT 1994.5-up
- EZGO ST and ST Sport on that same frame family
- EZGO Valor 2017-up
It does not fit the EZGO RXV 2008-up or any Club Car. Different chassis, different pan, different part.
Why the half-year? Midway through 1994, E-Z-GO swapped the Marathon body for the Medalist on a new frame. Catalogs write 1994.5 because the change landed inside the model year.
The TxT body, the ST and ST Sport utility versions, and the Valor 2017-up all grew from that frame family.
Cushion set or flip seat? Match your cart to a case
The frame under the bench decides the purchase, not comfort.
- Rear frame present, trim dead. Buy the $108.74 cushion set. It covers both surfaces of the bench.
- No rear frame at all. Buy the complete rear flip seat kit for the EZGO TxT 1994.5-up at $370.14. It brings the frame, the hinge, the backrest, and the flip-down cargo bed.
- Front bench worn too. Add the front cushion seat cover for the EZGO TxT 1994.5-up at $45.84.
Buy cushions with no frame and you own trim with nothing to stretch it over.
Why the frame check comes before new vinyl
Your weight never travels through the vinyl. It goes through the foam, into the pan, then into the frame rails. Vinyl is only the wear layer stretched over that structure.
A sagging bench is usually a loose fastener or a tired pan, not dead trim. Pull the old set and the rails, welds, and pan are visible again. A cracked weld found now costs a bracket; found later, the new set.
One set, one kit, real numbers
Every part below is in stock today. Pick by what is bolted to your frame, not by the closest photo.
| Part | What it is | Real-world numbers |
|---|---|---|
| Rear seat cushion set | Bottom plus backrest cushion, black vinyl, for the TxT 1994.5-up, ST, ST Sport, and Valor | $108.74 (SKU 286967416970); the rear cushion set listing for the 1994.5-up TxT family — trim only |
| Rear flip seat kit | Complete rear seat for the TxT 1994.5-up: frame, hinge, cushions, flip-down cargo bed | $370.14 (SKU 297604838438); the flip seat kit for the 1994.5-up TxT — the buy when no rear frame exists |
| Front cushion seat cover | Front bench cover and foam refresh, TxT 1994.5-up | $45.84 (SKU 296090576831); the front cushion cover for the TxT 1994.5-up — the driver's side wears first |
| Front cushion seat cover, RXV | Front cover cut for the EZGO RXV 2008-up, a different platform | In stock under the front cushion cover for the RXV 2008-up — not interchangeable with the TxT version |
| Front cushion set, Precedent | Front seat bottom and back cushion set for the Club Car Precedent 2004-up | In stock under the front cushion set for the Club Car Precedent 2004-up — it never crosses to the EZGO pan |
| Forward and reverse switch assembly | Direction switch for TxT models from 1994 onward | $110.93 (SKU 283938716934); the switch assembly for the TxT from 1994 onward — same rear access window |
Everything in that table bolts on with hand tools and needs no programming. Soft trim and seat hardware live in the wider golf cart parts collection if a bracket turns out to be the real failure.
Keep the new vinyl alive: clean, condition, protect
Vinyl fails from the outside in. Sunlight pulls out the plasticizers, the oils inside vinyl that keep it soft, and the surface turns grey and cracks. Three steps slow that down.
- Clean. Mild dish soap in warm water on a soft cloth. For sunscreen film or road grime, use a cleaner made for marine or RV vinyl.
- Condition. Work in a vinyl conditioner after cleaning. It puts back what the sun drew out.
- Protect. Apply a UV protectant on a clean, dry surface, about once a month in season.
Four habits kill a set early:
- Solvent cleaners and bleach, which embrittle the surface
- Pressure washers aimed at seams, which soak the foam
- Covering or re-trimming over damp foam, which grows mildew
- Parking in full sun with no protectant — one summer does more damage than five winters
Installation sequence, and the mistakes that cost you years
The install is a hand-tool job, and the order matters because of the inspection it forces.
- Remove the old set and photograph the fastener positions first. Old trim shows where the lips, snaps, or hook-and-loop retention sat.
- Inspect the rails, uprights, and pan with the trim out. Look for cracked welds, rust bleed, a soft pan, and bent uprights.
- Set the bottom cushion on the rails and capture the pan edges. Never drag it sideways across a rail corner.
- Bolt the backrest to the uprights, then work the underside retention center-out. Alternate side to side so the tension spreads.
- Tighten by feel and stop before the vinyl dimples. A dimpled surface is a cut surface.
- Handle the adjacent wear item while the rear is open. A TxT direction switch that hesitates is a bolt-in swap in the same window.
Almost every early failure happens in the first hour: a fastener pulled too tight, a set stretched over an uninspected frame, or damp foam sealed under new trim. The same chassis-by-chassis logic runs through the full guide library on the KOEEP blog.
Work the list in order before the new set leaves the box.
- Confirm the chassis: TxT 1994.5-up, ST or ST Sport on that family, or Valor 2017-up
- Photograph the underside retention points before anything comes loose
- Sight the rails for rust and the uprights for cracked welds, then press the pan for soft spots
- Fasten center-out and stop the moment the surface stops moving
- Finish with protectant before the cart goes back outside
Frequently asked questions
Which models and years does this rear cushion set actually fit?
The rear pan of the 1994.5-up E-Z-GO frame family: EZGO TxT 1994.5-up, the ST and ST Sport on that family, and the Valor 2017-up. It does not fit the RXV 2008-up or the Club Car Precedent 2004-up.
My cart has no rear seat frame at all — can I just bolt on the cushion set?
No. Cushions are trim, not a seat — buy the complete rear flip seat kit for the EZGO TxT 1994.5-up at $370.14 instead.
What changed at 1994.5, and why do catalogs use that half-year?
Midway through 1994, E-Z-GO replaced the Marathon with the Medalist on a new frame, so the change landed inside the model year. Catalogs write 1994.5 to mark that split.
Will the set fit my RXV, or do I need a different part?
No — the RXV 2008-up is a different chassis with different pan geometry. The front cushion cover for the RXV 2008-up is stocked separately and does not interchange with the TxT cover.
How is the set installed, and what tools does it need?
Hand tools only: photograph the old retention points, inspect the frame with the trim off, then fit center-out and stop before the vinyl dimples. On a TxT from 1994 onward, swap a hesitating direction switch in the same window.
How do I keep the new vinyl from cracking again?
Clean with mild dish soap in warm water, condition after cleaning, and apply a UV protectant about once a month in season. Skip solvent cleaners and bleach, and keep pressure washers off the seams.
The front bench is wearing out too — is that the same part?
Same failure mode, different part. The front cushion seat cover for the EZGO TxT 1994.5-up is $45.84, and RXV and Precedent benches have their own fitment in the table above.
Re-trim the bench, or replace the seat — with the right part
Cushion sets, flip seat kits, and front covers for the 1994.5-up TxT family are in stock. Not sure which one your cart needs? Send us a request for a quote, email support@koeep.com, or WhatsApp +86 181 3883 8291.
- E-Z-GO official model lineup pages (ezgo.txtsv.com) — the current personal lineup, led by the Valor and the S4.
- Lake Erie Golf Cars dealer guide on the Valor — the Valor replaced the classic TxT in the consumer lineup.
- Canyon Lake Mobile 2026 Valor review — TxT-heritage platform, steel frame, rear leaf-spring suspension.
- Golf Cart Stuff model-year identification page — the Valor model run is 2017-present.
- Golf Cart Search, "EZGO Golf Cart Models by Year" — the Marathon-to-Medalist/TxT lineage.
- Golf Cart Stuff 2026 upholstery cleaning guide — mild dish soap and warm water as the routine cleaner.
- Mentor Golf Carts & Trailers seat-cleaning guide — marine and RV-grade vinyl cleaners for heavy soil.
- Energy golf cart seat-care article — the clean, condition, protect method.
- Owner forums (Buggies Gone Wild, Golf Carts Modified) — cushion-only products are cataloged for existing rear flip frames.
- KOEEP listing data (SKUs 286967416970, 297604838438, 296090576831, 283938716934) — in-stock pricing, fitment, and model coverage.